GHS Classification: Non-Hazardous, see SDS . If persons are exposed to this dust, they should be protected from dust inhalation by use of approved dust respirators. To protect against termites place adequate physical barriers such as membranes around below-grade EPS. SPL recommends storing of polystyrene in cool & dry place in a shade away from sunlight and heat. If persons are exposed to this dust, they should be protected from dust inhalation by use of approved dust respirators. What is Polystyrene? | Uses, Benefits, and Safety Facts Accumulation of blowing agents or dust in air could present flammability and explosion concerns. Its industry ranks the 5th largest creator of toxic wastes in the USA. Ensure EPS bead is transferred at slowest speed possible and that all transfer equipment is suitably earthed. It is resistant to acids, alkalis, salts, mineral oils, organic acids, and alcohols 41. Why Styrofoam (Expanded Polystyrene) Should Be Banned ... - Medium PDF Polystyrene The effect of microplastics (MP) exposure on the . TWA 200 ppm, Ceiling 600 ppm - 5 min. If the EPS dust from polystyrene beads is inhaled, it may cause temporary irritation and coughing. Polystyrene is a colorless, transparent polymer composed of styrene monomers and has a specific gravity of 1.04-1.07 g/cm 3. SECTION 8: Exposure controls/personalprotection 8.1 Control parameters 8.2 Exposure controls This was . The polystyrene melting point is 240 degrees Celsius. Introduction. . Causes damage to lungs through prolonged or repeated inhalation of dust . . Inhalation Only dust produced from machining EPS or small particles are likely to be inhaled. Chronic Health Effects: There is no known chronic health effect connected with long-term use or contact . PDF JABLITE LIMITED Environmental, Health and Safety Data Sheet Expanded ... A concentration of around 0.5 kg/m3 is sometimes given as "optimal". The polystyrene boiling point is 430 degrees Celsius. A concentration of around 0.5 kg/m3 is sometimes given as "optimal". Polystyrene dust, like other hydrocarbon based polymers in this form, is classi ed as a Group (a) ammable dust and precautions should be taken as required by Section 32 of the Factories . Polystyrene foam insulation has unique properties differentiating it from . PDF Sundolitt Expanded Polystyrene Control of Substances Hazardous to ... Avoid skin and eye contact with dusts to prevent mec hanical irritation. 21528-NAM-EN Potential Health Effects Principle Routes of Exposure Eye Inhalation Acute Effects • Eyes Dust may cause slight irritation • Skin No effects expected • Inhalation Dust may cause irritation of respiratory tract • Ingestion Ingestion of material is unlikely